An excellent source of renewable energy is a Solar panel that can power your home. This simple way to power your home will keep you from using fossil fuels and will save you a lot of money in the long run. Here are some ways to decrease your electric bill.
To get started with solar panels, you need to know what type of groups you will need. First of all, figure out how much electricity you need. Many calculators on the internet will help you with this. For a home that only uses about 2kW, you will need four panels.
Buying Solar Panel
Do not buy the first set of solar panels that you see. If you are looking for top quality panels, you will want to buy them from a reputable manufacturer. Once you find a company that has quality panels, then it is time to get your solar power installed.
The key is to find a contractor who handles solar systems. You should make sure that the contractor comes recommended by one of your neighbors. It is not a good idea to go with an unknown contractor unless you know that they have excellent references.
Choosing A Good Location
Before you even start installing your solar panel, you should choose a location where you can install the panels on your roof. You will want to make sure that you find a place that has no trees. It is a bad idea to place the panels on a roof that has any trees that could come down on the boards.
Get a metal rail around the panels to make sure that they do not fall.
You should not forget to put the power cord into each panel. It will make it easier to get the groups attached to the house later on. The power cord should connect to the circuit breakers that are already on the outside of the house.
Plugging The Power
Once you have done this, the next step is to plug the power cord into the solar panel. The cords design to plug into each other, but if the wires are not connected, the power will cut off. Make sure that you are using a brand name cord.
If you are near a power supply that has a short circuit, you will need to look at the ground wires that are nearby. If they are wet, you should stop whatever you are doing and call an electrician immediately. Make sure that you have enough cables for all of the panels that you will be installing.
Installing The Panels
Before you start installing the panels, you will need to get the right size of the reflector. It directs the rays of the sun back into the home so that it heats the air inside. You can use a box or some other large surface to reflect the rays from the sun.
Once you have installed the reflector, you will need to get the wiring for the lights that are going mount inside the home. You will also need to find a light switch that will turn the lights on and off. You will also need to find an amplifier that will increase the power of the solar panels you don’t use them.
Once you install the solar panels, you will begin to see the difference in your electric bill. You should see an increase of about 10%.